Landfill leachate treatment by electrolysis and preparation of low cost activated carbon

Abstract

This study investigated the effects of different parameters on the removal efficiencies of organic and inorganic pollutants in landfill leachate treatment by electrolysis. Different parameters were considered such as the electric potential (e.g., 24, 40 and 60 V), hydraulic retention time (HRT) (e.g., 40, 60, 80, 100 and 120 min), sodium chloride (NaCl) concentration (e.g., 1, 3, 5 and 7%), pH (e.g., 3, 7 and 9), electrodes materials (e.g., aluminum (Al) and iron (Fe)) and distance between electrodes (e.g., 1, 2 and 3 cm). The best operational condition of electrolysis was then recommended. The electric potential of 60 V with HRT of 120 min at 5% of NaCl solution using Al as anode and Fe as cathode (kept at a distance of 3 cm) was the most efficient condition which increased the removal efficiencies of various parameters such as turbidity, salinity, total suspended solids (TSS), total dissolved solids (TDS), biochemical oxygen demand (BOD), chemical oxygen demand (COD) and heavy metals (e.g., Zn and Mn). The higher removal percentages of many parameters, especially COD (94%) and Mn (93%) indicated that the electrolysis is an efficient technique for multi-pollutants (e.g., organic, inorganic and heavy metals) removal from the landfill leachate. Two raw materials, sago palm bark (SPB) and date pits, were utilized as precursors to prepare high porosity activated carbon (AC). The porosity of these two raw materials was compared with that of commercial AC made from coconut shells. The physicochemical activation method was used for AC preparation, and it consisted of two steps, carbonization and activation. The activation process was performed using zinc chloride (ZnCl2) as an activation agent. N2 adsorption-desorption analysis was carried out to characterize the porosity of AC. Thermogravimetric analysis (TGA) was conducted for the two raw materials. The adsorbent made from SPB, which showed the maximum surface area of 1634 m2/g at the 700°C activation temperature for one hour, while the surface area of prepared AC from date pits was 1367 m2/g. Both prepared ACs had a larger surface area than commercial AC made with coconut shell (1348 m2/g).